Time-Out Timer (Tot); Locking The Transmit Band; Transmit Frequency Selection During Simultaneous In-Band Reception - Kenwood TM-732A Instruction Manual

M§ ADVANCED TRANSMIT FUNCTIONS
1. Time-Out Timer (TOT) 2. Locking the Transmit Band
A Time-out-timer function has been provided to protect It is possible to lock the transceiver so that the
the radio from accidentally locking the unit in transmit for transmit band is not accidently changed. This locks
long time periods. This function allows you to specify the second band into a receive only mode.
the maximum transmit key down time.
Options include; 3, 5, 10, 20, 30, or no time limit.
(The factory default is no time limit.)
(©) Function selection
1. Press the F key momentarily.
2. Press the BAND SEL key that corresponds with the
(©) Function selection desired transmit only band. A dot will appear to
1. Turn the power switch OFF. the right of the 100KHz column to indicate which
2. Press and hold the LOW key and turn the power ON. band is transmit only.
The current selection will appear in the display.
PP Be To cancel the assignment press repeat steps 1 and 2
Sight
rr goog repair
ax "asa cw ene | 3. Transmit Frequency Selection
during Simultaneous In-band
Reception.
It is possible to select either frequency as the transmit
3. Turn the tuning control to select the maximum key frequency dufing sinunaresas intend ecenhon
down time. TOT will appear in the display for all
selections except OFF. (receiving on two different frequencies in the same
4. Press any key to return to the normal frequency band). To select the desired transmit frequency simply
display. press the BAND Sel key that corresponds with the
desired transmit frequency.
If you should activate the Time-out-timer function a
beep will sound from the speaker and the transceiver Note:
will return to the receive mode. You will need to press Reception on the other frequency will not be possible
the PTT switch to transmit again. while the PTT key is depressed.
34