Side Tone Level; Beep Tone Selectiol; Beep Tone Level - Kenwood TS-440S Instruction Manual

>
. Cut the lead of diode D65 Jocated below the dip
switch on the control unit.
. Reverse steps 1.—3. to reassemble the radio.
Notes:
1. When reassembling the radio make sure that
you do not cut or pinch any wires between the
chassis and front panel!
. De not alter the settings of the dip switch. They
are factory adjusted, and damage or misoper-
ation may result.
a
Nn
Control unit
5-8-6. Side tone level
1. Remove the top cover. ips
2. Adjust VR-9 for your reference. Das ~
iW yi em
3. Replace the top cover.
es
Control unit
5-8-8. Beep tone level
1. Remove the top cover.
2. Adjust VR-10 for your reference.
3. Replace the top cover.
IF unit
5-8-7. Beep tone selection
The audio oscillator that provides the Morse Code sig-
nal when you press a mode key may be changed to
provide only a single confirmation tone by cutting di-
ode D65 on the Control unit.
1, Remove the top and bottom covers fram the radio.
2. Remove the countersink screws (2 on each side}
that secure the frant panel to the chassis and gently
pull the front panel forwards.
3. Remove the 5 small round head screws that secure
the shield plate (2 on the top and 3 on the bottom}
to the front panel, and remove the shield plate.
25