Kenwood TM-732A Instruction Manual page 30

3. Press the F key momentarily. The F indicator will
light on the display, and a memory channel number
will appear.
4. Select any memory channel using the Tuning control
or microphone UP/DWN keys.
(For example: CH10)
O's
[eo]
i} CAL
| ) ——
asi.
5. Press the MR key for longer than 1 second within 10
seconds of selecting the memory channel number.
The F and memory channel indicators and the* —
and "+" indicators disappear, then the "—" and
"+" indicators light again, and the transmit
frequency setting mode is entered.
6. Select the desired transmit frequency.
(For example 145.620MHz)
lo 90 | + OR — Push" = a
= Then MR" M if
LIVI Pret The Rahmiack Sei
7. Press the MR key.
To confirm the contents of the odd split memory
channel:
Press the MR key. The programmed receiver frequency
should appear in the display along with both a "—" and
"+-" offset direction indicator. This signals you that this
channel has an odd split entered.
To check the transmit frequency press the REV key.
The transmit frequency will appear in the display.
BUS antge Te, Cw Rat dly
2. Memory Channel Recall
1. Press the MR key to select the memory mode. The
memory channel that was used previously will
appear in the display.
2. Rotate the Tuning control or press the microphone
UP/DWN keys to select the desired memory
channel.
Note:
All memory channel data, except the frequency, can be
changed from the memory recall mode with out
affecting the actual memory contents. If you wish to
store the ia data into memory. you.should press