Table of Contents
Advertisement
- Enter the number of hours before the next service visit: « HSr ». Adjustable from 100 to 5000 hours. Allow at least one service per year.
* Select the value to be modified
* Adjust the value using the coder
- Enter the average hours per day that the unit is likely to operate: « H-d ». Adjustable from 1 to 24 hours.
* Select the value to be modified
* Adjust the value using the coder
7.3 RE-INITIALISATION OF THE MAINTENANCE COUNTER
- Go into the service screen
- Press the "installation parameter" button
- Enter the PIN code for the installer "INSB"
- Validate "V": when all the code has been entered and it is correct access the menu or start on the PIN number again.
- Re-initialise the remaining time before the next service.
Note: If the time remaining before the next maintenance is less than or equal to 0, error code i84 will be displayed in error codes
7.4 CONNECTING THE TERMINALS TO THE HEATING ELEMENTS
- The terminals on the heating elements must be fitted with two brass washers, a serrated washer and a brass nut, as shown in the diagram below
- To tighten, use a flat spanner as a counter-key on the hexagonal part of the heating element connection and tighten the brass nut with a torque
screwdriver to 4 N m
F49572 (07-23)
Page 20
➔
Frequency of maintenance
➔
Level of use per day
VULCAN
A division of ITW Food Equipment Group LLC
P.O. Box 696
Louisville, KY 40201
3VE490072EM – 06/23
Advertisement
Table of Contents
