Procedures For Changing Components; Location Of The Technical Components; Access To Components - Vulcan-Hart PRECIPAN VPP28 Maintenance Manual

Intelligent braising pan

Hide thumbs Also See for PRECIPAN VPP28:

Installation manual (20 pages)

Operation manual (54 pages)

Table Of Contents

Table of Contents

8.1 LOCATION OF THE TECHNICAL COMPONENTS

In the left hand facia

- Retractable spray hose

Behind the tank cladding

- Elements

- Tank base probe

- PT100 probe...

Behind the lower panelling

- Electrical connections

- Flow regulator, Solenoids ...

WARNING: The unit must be disconnected electrically during maintenance work and whilst replacing parts.

8.2 ACCESS TO COMPONENTS

8.2.1 BEHIND THE CONTROL FACIA

● Removing the control facia

- Undo the two HM5 x16 screws under the facia

- Open it: Pull gently downwards then towards you

- Place the facia next to the unit to avoid having to

disconnect the power socket and the connections for the

USB and core probe

● Access to the electrical board

- Pull the electrical drawer towards you

Be careful with the cables when pulling the board out.

8.2.2 BEHIND THE LOWER PANELLING

● Removing the lower panelling

- Undo the two M5 x16 pan-head screws

- Remove the panel

▪

Lift slightly then towards you

8.2.3 BEHIND THE TANK CLADDING

● Removing the tank cladding

- Undo the three M5 x16 pan-head screws under the

front edge of the tank

- Undo the two HM5 x16 screws under the cladding

- Remove the cladding

▪

Tilt the facia by pulling the bottom towards

you then disengage at the top

F49572 (07-23)