Epson WF-C5790 Service Manual page 562
Color inkjet printer
Hide thumbs
Also See for WF-C5790:
- Start here (4 pages) ,
- User manual (413 pages) ,
- User manual (414 pages)
Table of Contents
Advertisement
EPSON WF-C5790/WF-C5790a/WF-C5710/ET-8700/WF-C5210/WF-C5290/WF-C5290a
4.
Move the CR unit to the thickness gauge and check whether or not the CR
Unit touches the thickness gauge.
• If does not touch the thickness gauge: Proceed to step 5.
• If touches the thickness gauge:
4-1. Move the CR unit to the center part of the printer.
4-2.Move the PG adjustment cam on the right side by one notch in the "+"
direction.
4-3. Move the CR unit to the thickness gauge again and check whether or not
the carriage touches the thickness gauge.
• If touches the thickness gauge, repeat the work of
until the CR Unit does not touch the thickness gauge.
5.
Place the thickness gauge (1.42 mm thickness gauge + 0.08 mm Teflon tape)
at position B shown in
Figure
•Even for the Full digit side, follow the same procedure to adjust the PG
adjustment cam on the left side until the CR Unit is no longer in contact
with the thickness gauge.
6.
Place the thickness gauge (1.62 mm thickness gauge + 0.08 mm Teflon tape)
at position A shown in
Figure
7.
Move the CR unit to the thickness gauge and check whether or not the
carriage touches the thickness gauge.
• If touches the thickness gauge:
• If does not touch the thickness gauge: Perform the adjustment in the
7-1. Move the CR unit to the center part of the printer.
7-2.Move the PG adjustment cam on the right side by one notch in the "-"
direction.
7-3.Move the CR unit to the thickness gauge again and check whether or not
the CR Unit touches the thickness gauge.
• If does not touch the thickness gauge, repeat the work of
Step 7-3
until the CR Unit touches the thickness gauge.
8.
Place the thickness gauge (1.62 mm thickness gauge + 0.08 mm Teflon tape)
at position B shown in
Figure
•Even for the Full digit side, follow the same procedure to adjust the PG
adjustment cam on the left side until the CR Unit comes in contact with the
thickness gauge.
9.
Tighten the two fixing screws of the PG adjustment cam positioned on the left
and right, and the four fixing screws of the CR guide frame.
Adjustment
Perform the adjustment in the
procedure below.
Step 4-1
to
Step 4-3
7-4.
7-4.
Proceed to step 8.
procedure below.
Step 7-1
7-4.
Adjustment and Inspection Details
to
Revision A
562
Confidential
Advertisement
Chapters
Table of Contents
Troubleshooting
