GE Innova 2100-IQ Preinstallation Manual page 36

Innova 2100-IQ, 3100/3100-IQ, 4100/4100-IQ Cardiovascular Imaging System Pre-Installation Manual
GE Healthcare
The s5i/GE rev 2 release is based on
• S5x platform
• 3.0.2 software release
The new s5x platform introduces 2 new components:
• A new IVUS catheter type (rotational catheter) in addition to the current one (phased array
catheter):
The same Graphical User Interface and application will be used for both catheter types, the
user only needs to plug the desired Patient Interface Module and insert a corresponding
catheter type to be able to start imaging.
• A new application (FFR):
It is a new diagnostic method, the so-called FFR TM (Fractional Flow Reserve) mode which
serves as a blood pressure measurement device in the vascular veins. In this mode the
Volcano s5x device can measure the difference between the patient's aortic and distal
pressure, which result serves as a good decision-helper for the type of treatment.
It also answers some user enhancement requests:
• Introduction of a sealable Patient Interface Module to prevent oxidation of the catheter
connector.
• Introduction of a set of cable clamps and a Patient Interface Module's rail hanger with cable
strain relief to decrease cable damage.
• Introduction of a new monitor cable type to increase the system reliability.
• Introduction of a new tableside-based TouchPad device to provide an enhanced user interface,
focusing mainly on characterization of the vessel wall on the IVUS image.
36
Direction 5160944-13-1EN, Revision 2
1 Description of Innova System