Module Assembly Parts - Tandon TM-100-1 Operating And Service Manual

5.14
5.14.1
5.14.2
MODULE ASSEMBLY
Remove the Logic PCBA (see Section 5.2).
Remove the Cone Lever Assembly (see Section 5.4).
5.14.3 With a Phillips screwdriver, remove the three (3) mounting screws and their flat washers that attach
the Module Assembly to the chassis (see Figure 5-29).
5.14.4
MOUNTING _ _ . ~
SCREW
r.T.--,
FLAT
_..p-®
WASHER
I(!;?_
Figure 5-29
Module Assembly Parts
NOTE
One screw is located on the top middle at the back of the chassis.
The other two screws are located underneath the middle of the
chassis.
Remove the Module Assembly from the chassis by lifting it up.
5.14.5 Install the new Module Assembly by placing its left-hand side against the module spring , and by com-
pressing the module spring to seat the other side of the Module Assembly .
5-32