Table of Contents
Advertisement
5.6
ACTIVITY LIGHT EMITTING DIODE (LED) ASSEMBLY
5.6.1
Remove the Logic PCBA (see Section 5.2).
5.6.2
Cut the two (2) cable harnesses that attach the Activity LED Assembly and the Write Protect Switch
Assembly to the chassis in front of the drive motor and to the bundle of wires in back of the drive motor (see Figure
5-9).
Figure 5-9
Activity LED Assembly Cable Harnessing
CABLE
HARNESSES (2)
5.6.3
Remove the retaining collar that holds the Activity LED Assembly cables to the LED grommet by tak-
ing a pair of needle nose pliers and gently pulling the retaining collar away from the front panel (see Figure 5-10)
.
5.6.4
Snap out the Activity LED Assembly from the LED grommet.
5.6.5
Remove the entire Activity LED Assembly from the disk
drive.
5.6.6
Snap the new Activity LED Assembly into the front panel LED grommet.
5.6.7
Push the retaining collar over the LED grommet.
5.6.8
Install a new cable harness to attach the Activity LED Assembly and the Write Protect Switch Assem-
bly to the chassis by putting the cable harness through the two (2) holes in the bottom of the chassis (see Figure
5-9)
.
NOTE
Smooth out the cables before harnessing them.
5-12
Advertisement
Table of Contents
