Table of Contents
Advertisement
5.4
CONE LEVER ASSEMBLY
5.4.1
Remove the Logic PCBA from the disk drive (see Section 5.2).
5.4.2
Open the front
door,
located in the front panel of the disk
drive.
NOTE
The Cone Lever Assembly automatically lifts up.
5.4.3
Cut the tie wrap that attaches the top index cables to the Cone Lever
Assembly.
5.4.4
With a Phillips screwdriver, remove the mounting screw that attaches the index emitter holder to the
Cone Lever Assembly (see Figure 5-4).
MOUNTING SCREW
Figure 5-4
Cone Lever Assembly Harnessing and Mounting
5.4.5
Unloop the two (2) head cables from the right rail in two (2) places.
5.4.6
At the rear of the Cone Lever
Assembly,
cut the two (2) cable harnesses that hold the stepper motor
cables in place (see Figure 5-5).
5.4.7
With a Phillips screwdriver, remove the two (2) mounting screws that attach the Cone Lever Assembly
to the chassis.
5.4.8
Gently slide the head carriage to the front of the disk
drive,
i.e.
,
the Track 39 position
.
5-6
Advertisement
Table of Contents
