Table of Contents
Advertisement
Figure 5-19
Drive Motor Assembly Pulley
NOTE
Ensure that Connector P21
's
cables are closer to the Servo PCBA
than to the front of the disk drive.
SMALL
PULLEY
5.10.9
With a Phillips
screwdriver,
mount the Drive Motor Assembly to the
chassis,
using the two (2) mount-
ing screws and the two (2) shoulder washers previously set aside.
5.10.10
Reinstall the drive belt (see Section 5.1
).
5.10.11
Plug Connector P21
into
the Servo PCBA (see Figure 5-18).
5.10.12
Reinstall the Logic PCBA (see Section 5.2).
5.10.13
Check the Instantaneous Speed Variation (ISV) (see Section 2.1.2).
5. 10.14
If the ISV meets the specification, adjust the drive motor speed (see Section 2.1.1 ).
5.10.15
Recheck the ISV
(see
Section
2.1.2).
5-23
Advertisement
Table of Contents
