Cone Lever Assembly Cable Harness - Tandon TM-100-1 Operating And Service Manual

Figure 5-6
CONE LEVER
----ASSEMBLY
Cone Lever Assembly Cable Harness
5.4.16 Gather together and harness the stepper motor cables in two (2) places at the rear of the Cone Lever
Assembly (see Figure 5-5).
5.4.17
5.4.18
Close the front door of the disk drive to engage the cone and the hub.
Ensure that the cone is centered in the lever (shaft) hole.
5.4.19 With a Phillips screwdriver, tighten the two (2) mounting screws that attach the Cone Lever Assembly
to the chassis.
5.4.20 Check to ensure there is clearance between the E-ring and the washer when the cone is clamped-
the result of the front door being closed.
5.4.21
NOTE
The cone shaft E-ring should be between 0.01 0" and 0.025" above
the cone lever when the Cone Lever Assembly is in the latched
position .
If necessary, adjust the clearance by adding or deleting a washer located under the E-ring (see Figure 5-7).
5-8