Table of Contents
Advertisement
RETAINER
SLOT OPENING
HEX HEAD
SCREW
Figure 5-31
Spindle Assembly Retainer and Hex Head Screws
5.15.11
Engage the retainer by rotating it clockwise until its slot openings are under the two (2) hex head
screws.
5.15.12
Using a one-quarter
(¼
)inch
wrench,
tighten the two (2) hex head screws that attach the bearing re-
tainer to the chassis (see Figure 5-31 ).
5.15.13
Lay the disk drive on its side.
5.15.14
With a Phillips
screwdriver,
while holding the hub, insert the large pulley, flat washer, and the mounting
screw into the bottom of the chassis (see Figure 5-30).
5.15.15
While holding the
hub,
tighten the mounting screw (see Figure 5-30)
.
5.15.16
Check to ensure that the shaft does not wobble when the spindle turns.
NOTE
A wobble may indicate a bad bearing
.
5.15.17
Reinstall the drive belt (see Section 5.1
).
5-35
Advertisement
Table of Contents
