Table of Contents
Advertisement
5.16
5.16.1
LATCH PLATE ASSEMBLY
Remove the Logic PCBA (see Section 5.2)
.
5.16.2
With a Phillips screwdriver, loosen the two (2) mounting screws that attach the Latch Plate Assembly
to the Cone Lever Assembly (see Figure 5-32).
5.16.3
5.16.4
5.16.5
5.16.6
LATCH PINS (2)
Figure 5-32
MOUNTING
~.....,- SCREWS (2)
~
I
I
LATCH
I
.!.
' . . - -
INHIBITOR
.!.
I
I
I
I
I
I
I
Latch Plate Assembly Mounting Screws and Latch Inhibitor
Remove the two (2) mounting screws from the Latch Plate Assembly.
Remove the latch inhibitor and the Latch Plate Assembly from the disk drive.
While holding
the
Cone Lever Assembly down, insert the new Latch Plate Assembly into its tracks.
Close the front door of the disk drive.
5.16.7
Still holding the Cone Lever Assembly down, place the
latch inhibitor
on top of the Latch Plate
Assembly.
5.16.8
With a Phillips
screwdriver,
install but do not tighten
the two (2)
mounting screws that attach the latch
inhibitor and the Latch Plate Assembly to the Cone Lever
Assembly.
5.16.9
Open the
front
door located
in
the front panel.
5.16.1 O
Insert a diskette into the disk
drive.
5-37
Advertisement
Table of Contents
