Tandon TM-100-1 Operating And Service Manual page 73

5.7 FRONT PANEL
5.7.1 Remove the Logic PCBA (see Section 5.2).
5.7.2 Using a pair of needle noc;e pliers, remove the two (2) bushings located on the right-hand and the left-
hand top sides of the front panel by pulling up on them while using a twisting motion (see Figure 5-11 ).
Figure 5-11
Front Panel Bushings
5. 7.3 Remove the retaining collar that attaches the Activity LED Assembly to the front panel by taking a pair
of needle nose pliers and gently pulling the retaining collar away from the front panel (see Figure 5-12).
NOTE
Slide the retaining collar over the Activity LED Assembly.
5.7.4 Snap out the Activity LED Assembly from its grommet.
5.7.5 With a Phillips screwdriver, remove the two (2) mounting screws that attach the front panel to the
chassis (see Figure 5-13).
NOTE
These two mounting screws are located underneath the front end of
the disk drive.
5.7.6 Lift up the front panel, and remove it from the chassis.
5-14