Introduction; S Pindle Drive Motor Checks And Adjustments; Long-Term Drive Motor Speed Checks And Adjustments - Tandon TM848-1 Operating And Service Manual

M AINTENANCE C H E CKS AND ADJUST M E N T S
2. INTR O DUGTI ON
This section is for the use of the OEM Repair Department. It contains checks and adjustments that are
used during the normal life of the drive.
Before applying power to the drive or doing any checks or adjustments, visually inspect the drive to
ensure that it has no missing or broken parts.
The following equipment is required for checks and adjustments:
1. A dual-channel, wideband oscilloscope:
2. An exerciser or software routine capable of stepping the drive to any track, selecting the
upper or lower head, and writing a 1F, all zeros if FM,or a 2F, all ones if FM, pattern on the disk.
3. A Phillips screwdriver
4. A set of Allen wrenches
5. A flat blade screwdriver
6. A blank diskette
7. An alignment diskette:
8. Integrated circuit dip clips, 14 and 16 pin
2.1
S PINDLE DRIVE MOTOR CH E C K S AND ADJUS T M E N T S
The long-term drive motor speed adjustment ensures that the motor's speed is within the range of
tolerance specified. The motor speed specification is 360 RPM + 1 .25 percent.
2.1.1. Lo ng - T e r m Drive Motor Speed Checks and Adjustments
A. Preliminary checks required:
Verify power: + 24 V D. C. +10 percent
B. Apply power to the drive.
C. Activate the drive motor on the interface line.
D. Insert a work diskette.
SECTION II
D y s a n P/ N 3 6 0 /2 A or equivalent
+5V D. C. ~ 5 p e r ce nt
T e k t r o nix 465 or equivalent
2-1