Pentair FLECK 5800 XTR2 Service Manual page 7

TOUCHSCREEN CONTROL QUICK START
continued
5. After pressing , the Home screen (Figure 8) appears.
Day and Time
Regeneration
Cycle Wheel
Vacation
Assistance
Figure 8 Home Screen
The Day and Time button will be flashing, indicating that the
day of the week and time need to be set. If the date and time
are incorrect, press the Day and Time button to update to
the correct day and time. The Day and Time screen (Figure
9) appears.
Day
Month
Hour
Minute
Figure 9 Day and Time Screen
Press the Day of Week, Hour, Minute, and AM/PM/HR
buttons to adjust the values to the correct day of week
and time. Setting the value of the AM/PM/HR button to
HR changes the display to a 24 hour clock. Press the Day,
Month, and Year buttons to adjust the values to the correct
date. Press the button when finished to return to the
Home screen. Press
without saving.
7 • FLECK 5800 XTR2 Service Manual
Next Scheduled
Regeneration
Current Cycle
Step
Diagnostics
Regeneration
Settings
Year
Day of Week
AM/PM/HR
to return to the Home screen
6. Start a regeneration by pressing the Regeneration button
. The Regeneration screen appears (Figure 10).
Figure 10 Regeneration Screen
• Press now to begin a regeneration immediately, or
press at regen. time to queue the regeneration for the
programmed regeneration time (2:00 AM default for
softeners, 12:00 AM default for filters). Pressing at regen.
time again will cancel the manual regeneration.
• During Regeneration, press the
advance to the next cycle step. Once in regeneration, the
volume or time will be displayed below the
7. For softener systems, put salt in the brine tank.
NOTE: Do not use granulated or rock salt.
The unit is now fully programmed and ready to treat water.
This quick setup uses the control's default settings, which are
appropriate for most residential applications.
262.634.2386 | greatlakesintl.com
button to immediately
button.