Table Of Contents; Job Specification Sheet; Heet - Pentair FLECK 5800 XTR2 Service Manual

TABLE OF CONTENTS

JOB SPECIFICATION SHEET .................................................... 2
INSTALLATION ......................................................................... 3
START-UP INSTRUCTIONS/FLUSHING & CONDITIONING ..... 5
SYSTEM DISINFECTION ........................................................... 5
TOUCHSCREEN CONTROL QUICK START ............................... 6
TOUCHSCREEN CONTROL FEATURES.................................... 8
MASTER SETTINGS PROGRAMMING ...................................... 12
MASTER RESET ....................................................................... 17
CONTROL OPERATION ............................................................. 17
ALARMS AND ERRORS ............................................................ 17
MASTER SETTINGS REFERENCE CHART ............................... 18
TROUBLESHOOTING ................................................................ 19

JOB SPECIFICATION SHEET

ERROR ALERTS........................................................................ 20
Job Number: ___________________________________________________
Model Number: _________________________________________________
5800 XTR2 CONTROL VALVE ASSEMBLY ................................. 21
Water Hardness: _______________________________________ ppm or gpg
5800 CONTROL VALVE ASSEMBLIES....................................... 22
Capacity Per Unit: _______________________________________________
5800 VALVE ACCESSORIES ...................................................... 23
Mineral Tank Size: ______________ Diameter: ________ Height: _________
Salt Setting per Regeneration: _____________________________________
TURBINE METER ASSEMBLY - P/N 60626 ............................. 25
PADDLE METER ASSEMBLY -P/N 60086-50 ........................... 25
1. Meter Size:
BYPASS VALVE ASSEMBLY (METAL) ........................................ 26
BYPASS VALVE ASSEMBLY (PLASTIC) ..................................... 26
SAFETY BRINE VALVE .............................................................. 27
WATER CONDITIONER FLOW DIAGRAMS ............................... 28
DIMENSIONAL DRAWINGS ...................................................... 30
2. Regeneration Type:
TRANSFORMER PORT LOCATION ........................................... 31
INJECTOR FLOW DATA ............................................................. 32
WIRING DIAGRAM .................................................................... 33
3. Cycle Settings:
• The information, specifications and illustrations in this manual are based on the
latest information available at the time of release. The manufacturer reserves 4. Drain Line Flow Control:_____________________________ gpm
the right to make changes at any time without notice.
5. Brine Line Flow Control: ____________________________ gpm
6. Injector Size#: ________________________________________
• This manual is intended as a guide for service of the valve only. System
7. Battery Install/Change Date: ______________________________
installation requires information from a number of suppliers not known at
the time of manufacture. This product should be installed by a plumbing
IMPORTANT PLEASE READ:
professional.
• This unit is designed to be installed on potable water systems only.
• This product must be installed in compliance with all state and municipal
plumbing and electrical codes. Permits may be required at the time of
installation.
• It is established that when daytime water pressure exceeds 80 psi (5.5 bar),
the maximum pressure rating of 125 psi (8.6 bar) can be exceeded. A pressure
regulator must be installed on this system or warranty is voided.
• Do not install the unit where temperatures may drop below 32°F (0°C) or above
120°F (52°C).
• Do not place the unit in direct sunlight. Black units will absorb radiant heat
increasing internal temperatures.
• Warranty of this product extends to manufacturing defects. Misapplication of this
product may result in failure to properly condition water, or damage to product.
• A prefilter should be used on installations in which free solids are present.
• In some applications local municipalities treat water with Chloramines. High
Chloramine levels may damage valve components.
• Correct and constant voltage must be supplied to the controller to maintain
proper function.
CALIFORNIA PROPOSITION 65 WARNING
2 • FLECK 5800 XTR2 Service Manual
A. 3/4" Paddle Wheel Turbine
B. 1" Paddle Wheel Turbine
C. 1-1/2" Paddle Wheel Turbine
D. 2" Paddle Wheel
E. 3" Paddle Wheel
F. Generic_________Pulse Count__________Meter Size__________
A. Time Clock
B. Meter
C. Sensor
A. Backwash: ____________________________________ Minutes
B. Brine and Slow Rinse: ___________________________ Minutes
C. Rapid Rinse: ___________________________________ Minutes
D. Brine Tank Refill: _______________________________ Minutes
IMPORTANT PLEASE READ:
E. Pause Time: ___________________________________ Minutes
F. Second Backwash: ______________________________ Minutes
This product contains chemicals known to the
State of California to cause cancer or birth
defects or other reproductive harm.
JOB SPECIFICATION SHEET
Job Number: ___________________________________________________
Model Number: _________________________________________________
Water Hardness: _______________________________________ ppm or gpg
Capacity Per Unit: _______________________________________________
Mineral Tank Size: ______________ Diameter: ________ Height: _________
Salt Setting per Regeneration: _____________________________________
1. Meter Size:
A. 3/4" Paddle Wheel
B. 1" Paddle Wheel
C. 1-1/2" Paddle Wheel
D. 2" Paddle Wheel
E. 3" Paddle Wheel
F. Generic_________Pulse Count__________Meter Size__________
2. Regeneration Type:
A. Time Clock
B. Meter
C. Sensor
3. Cycle Settings:
A. Backwash: ____________________________________ Minutes
B. Brine and Slow Rinse: ___________________________ Minutes
C. Rapid Rinse: ___________________________________ Minutes
D. Brine Tank Refill: _______________________________ Minutes
E. Pause Time: ___________________________________ Minutes
F. Second Backwash: ______________________________ Minutes
4. Drain Line Flow Control:_____________________________ gpm
5. Brine Line Flow Control: ____________________________ gpm
6. Injector Size#: ________________________________________
7. Battery Install/Change Date: ______________________________
CALIFORNIA PROPOSITION 65 WARNING
This product contains chemicals known to the
State of California to cause cancer or birth
defects or other reproductive harm.
262.634.2386 | greatlakesintl.com
Turbine
Turbine
Turbine