Pentair FLECK 5800 XTR2 Service Manual page 15

MASTER SETTINGS PROGRAMMING
continued
Sensor Regeneration Type
From the main Master Settings screen (Figure 18) press the
valve button to display the valve screen.
Press the regen. type button and scroll through the options
until the tank sensors option is seen. Press the
tank sensor.
NOTE: Hardness and hardness units settings will no longer be
available when in the regen. type: tank sensors.
Settings Review
From the main Master Settings screen (Figure 18) press the
settings review button to display the Settings Review screens,
which display a read-only summary of all programmed settings
in the control.
Figure 29 Format Settings Review Screen
Use the navigation arrows at the top of the screen to scroll
through the parameters currently set in the control. The
Settings Review screens are formatted similarly to the
corresponding screen where each parameter was set. Press
to return to Master Settings.
15 • FLECK 5800 XTR2 Service Manual
Non-Factory Settings
After all parameters in Master Programming have been set,
these settings can be saved to a custom profile by pressing
on the main Master Settings screen (Figure 18). After pressing
, the Non-Factory Settings screen appears.
to select
Press to save all programmed Master Settings parameters
to non-factory settings. At any point, the control can be reset
to these saved custom settings. By performing a custom reset,
any setting that is subsequently programmed without saving to
non-factory settings will be reset to the previously saved non-
factory settings in the control.
Diagnostics
The control records and displays a variety of diagnostic data to
assist with troubleshooting performance issues and fine-tuning
system efficiency. Press the Diagnostics button
Master Settings or Home screens to view the Diagnostic
screen.
Figure 30 Non-Factory Settings Screen
Figure 31 Diagnostic Screen
262.634.2386 | greatlakesintl.com
from the