Pentair FLECK 5800 XTR2 Service Manual page 16

MASTER SETTINGS PROGRAMMING
continued
• Press the screen navigation arrows at the upper-right and
left of the screen to view each diagnostic parameter.
• Press the Error Log button
screen. To clear the Error Log, press the Reset button
then the Reset button again on the Clear All Error Logs
screen, then enter "1201" at the password prompt screen,
then press the Accept button to confirm.
Figure 32 Error Log Screen
• Press the Home button
NOTE: If a regeneration occurs while in the Diagnostic screen,
the unit will return to the main screen.
Parameter
Flow Rate
Peak Flow Displays maximum flow rate of water along
with date and time of occurrence, since last
Totalizer
Last Regen
Reserve
reserve type selected under master settings.
*This parameter is only available for meter
Software Version
No of Regens
initiated regenerations the system has gone
Regen Interval Displays the average length of time between
Daily Usage Displays average water usage for each day of
the week based on the usage on that day for
Usage Since Regen Displays water usage since last regeneration.
Last Setting Change Displays the date and time of the last update
NOTE: Only Peak Flow and Totalizer can be changed - they can be
reset to zero.
NOTE: Totalizer has a maximum value of 99,999,999. If this
number is reached, the Totalizer must be reset to zero to
continue tracking this value.
16 • FLECK 5800 XTR2 Service Manual
to access the Error Log
to return to the Home screen.
Description
Displays the current flow rate.
reset.
Displays total volume of water used since
last reset.
Displays when last regeneration occurred.
Displays the reserve volume based on the
delayed regeneration type.
Displays the software version installed on
the controller.
Displays how many manually and system
through since last reset.
regenerations based on the past four
regenerations.
the past six weeks.
to Master Settings.
USB Connection for Field Programming
The XTR2 features a USB port that allows you to connect a PC
to the control for field programming and diagnostic parameter
download.
NOTE: Field Programmer software is required for field
programming features. See XTR2 Field Programmer
Manual for more information on using the Field
Programmer software.
Pressing on the Format screen displays the USB screen.
Figure 33 USB Screen
When the USB screen appears, connect a USB cable to the
USB port on the control circuit board. Connect the other
end of the USB cable to a PC with the Field Programmer
software installed and follow the directions in the XTR2 Field
Programmer manual to complete the connection. Press
return to Master Settings.
NOTE: Do not remove USB cable from computer or control
while connected and transferring data. See the XTR2
Field Programmer manual for proper disconnection
procedure.
262.634.2386 | greatlakesintl.com
to