Canon WFT-E7 Instruction Manual page 28

Connecting to a Detected Network Manually
Entering the Access Point Encryption Key
Enter the encryption key (password) specified for the access point.

For details on the specified encryption key, refer to the access
point's instruction manual.
The screens displayed in steps 2 to 4 below vary depending on the

authentication and encryption specified for the access point.
Go to page 30 when the [IP address set.] screen is displayed

instead of the screens for steps 2 to 4.
28
Select a key index.
2
The [Key index] screen is displayed

only if WEP encryption is used by the
access point.
Select the key index number

specified for the access point, then
press <0>.
Select [OK] and press <0> to go to

the next screen.
Select the format and the number
3
of characters used for the key.
Select [OK] and press <0> to go to

the next screen.
Enter the encryption key.
4
Enter the encryption key using the

virtual keyboard (p.29), then press
the <M> button.
When a connection with the access

point is established, the [IP address
set.] screen (p.30) is displayed.