Table of Contents
Advertisement
If [Waiting to retry transfer...] is displayed
Once the cause of the error is eliminated, the images whose transfer
previously failed will be transferred automatically.
Note that if you cancel image transfer or turn off the camera, auto retry
is not performed. Follow the steps on page 44 to transfer the images.
11: Connection target not found
In the case of [EOSUtility], is EOS Utility running?
Start EOS Utility and re-establish the connection (p.52).
Are the transmitter and the access point set to use the same
encryption key for authentication?
This error occurs if the encryption keys do not match when the
authentication method for encryption is set to [Open system].
The setting is case-sensitive, so check upper- and lower-case
characters. Make sure that the correct encryption key for
authentication is entered on the transmitter (p.28).
12: Connection target not found
Are the target device and access point turned on?
Turn on the target device and access point, then wait a while. If a
connection still cannot be established, perform the procedures to
establish the connection again.
Responding to Error Messages
If image transfer via FTP fails after
shooting, the screen on the left is
displayed. Also, an error code number is
displayed on the transmitter's LCD
panel, and the <LAN> lamp blinks in red.
Check the error code number and
eliminate the cause of the error.
109
Advertisement
Table of Contents
