Raising The Windshield - Jeep Wrangler Owner's Manual

6. Lower the windshield gently until it contacts the
tie-down bumpers (if equipped).
Tie-Down Bumpers
1 — Washer Nozzle
2 — Bumper
3 — Tie-Down
7. Secure the windshield by passing a cinch strap
through the tie-down on either side of the hood and
on the windshield frame. Tighten the strap to secure
the windshield in place.
CAUTION!
Do Not Overtighten! Damage to the windshield could
result.
R T W
AISING HE INDSHIELD
1. Release the strap that secured the windshield in the
lowered position.
2. Raise the windshield.
3. Using the provided #40 Torx head driver, reinstall the
four Torx screws located along the interior of the
windshield. Secure them until they are snug, being
careful not to cross-thread the screws or overtighten.
GETTING TO KNOW YOUR VEHICLE
Interior Torx Screw Locations
1 — Outside Torx Screws
2 — Inside Torx Screws
4. Reinstall the windshield wiper arms using the
provided 15 mm socket. First, align the tips of the
blade to the "T" mark in the glass. Then, while holding
the arm in that position, reinstall the hex nut and
tighten until snug. Be careful not to overtighten.
Repeat for the other arm.
67