Raising The Windshield - Jeep GLADIATOR 2023 Owner's Manual

100 GETTING TO KNOW YOUR VEHICLE
NOTE:
Be sure to remove the cover before returning the wind-
shield to the normal position. Store the cover in the cargo
area.
Cleaning Instructions
During windshield down applications, dust/dirt can
accumulate in the cover and block the camera lens. Use a
microfiber cloth to clean the camera lens, module, and
inside cover, being careful not to damage or scratch the
module.
R T W
AISING HE INDSHIELD
1. Release the strap that secured the windshield in the
lowered position.
2. Raise the windshield.
3. Using the provided #T40 Torx head driver, reinstall
the four Torx head fasteners located along the
interior of the windshield (two on each side of the
header trim). Secure them until they are snug, being
careful not to cross-thread the fasteners or
overtighten.
Step Three
1 — Outer Torx Fasteners
2 — Center Torx Fasteners
4. Reinstall the windshield wiper arms using the
provided 15 mm socket. First, align the tips of the
blade to the "T" mark in the glass. Then, while holding
the arm in that position, reinstall the hex nut and
tighten until snug. Be careful not to overtighten.
Repeat for the other arm.
5. Reinstall the protective caps over the wiper arm hex
bolts and push gently until they snap into place.
Step Five
1 — Hex Bolt Cover Installed
2 — Hex Bolt Cover Removed
NOTE:
Make sure the windshield is raised prior to installing
the tops.