Jeep Wrangler Owner's Manual page 256

NOTE:
If necessary, push in on the assembly tab located inboard
behind the lamp housing.
3. Remove the three screws from assembly bracket to
access bulb sockets.
4. Rotate the appropriate socket a quarter turn counter-
clockwise, then remove it from the housing.
Bulb Removal
5. Pull the bulb straight from the socket to replace.
CENTER HIGH MOUNTED STOP LAMP (CHMSL)
The stop lamp is mounted on a bracket that extends
upward from the swing gate behind the spare tire. If
service is needed, obtain the LED Assembly from an
authorized dealer.
See the following steps to replace:
1. Remove the spare tire.
2. Remove the screws holding the tire carrier cover.
3. Remove two screws from lamp assembly and
disconnect electrical connector.
Refer to an authorized dealer for service.
LICENSE PLATE LAMPS
See the following steps to replace:
1. Reach under the vehicle to access the back of the
lamp.
2. Firmly grab the bulb by the two latch features and
squeeze them together to unlock the bulb from the
back of the lamp housing.
See an authorized dealer to replace LED assemblies.
SERVICING AND MAINTENANCE
REAR FOG LAMP
See the following steps to replace:
1. Reach under the vehicle to access the back of the
fog lamp.
2. Disconnect the wire harness connector from the fog
lamp connector receptacle.
3. Rotate the socket a quarter turn counterclockwise,
then remove it from the housing.
4. Pull the bulb straight out from the keyed opening in
the housing and then connect the replacement bulb
and reassemble.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the bulb
comes in contact with any oily surface, clean the bulb
with rubbing alcohol.
Refer to an authorized dealer for service.
255