River Rocks; Tumbled Stones; Glass - Jøtul GF 160 DV Installation And Operation Instruction Manual

River Rock Set 158055
• Orient the rock assembly to engage with the burner pins as
shown fig. 12.3a.
NOTE THE DIFFERENCE BETWEEN THE CORRECT
AND INCORRECT ORIENTATION (fig. 12.3b).
INCORRECT ROCK SET ORIENTATION WILL RESULT
IN POOR PERFORMANCE.
Figure 12.3a River Rock orientation - CORRECT.
WRONG
Figure 12.3b. Incorrect River Rock orientation.

Tumbled Stones 158054

• Apply the stones in a single layer across the burner surface.
The stones may cover porting, but take care that flat stones
do not completely block gas flow through the ports in a
single layer. Also, DO NOT OBSTRUCT THE AIR SPACE
BETWEEN THE BURNER PERIMETER AND THE
BURNER SKIRT. See fig. 12.4.
Figure 12.4. Tumbled Stone layout.
Clear/White Fire Glass 156815
Black Fire Glass 157342
• Do not use more than the four pounds (in two, 2 lb. bags)
of glass media provided. For best results, evenly spread the
contents of the bag over the entire burner plate, mounding a
crown toward the center.
• DO NOT COVER THE AREA IMMEDIATELY IN FRONT
OF THE PILOT ASSEMBLY. The carry-over ports directly in
front of the pilot assembly must remain clear to ensure proper pilot
ignition. See fig. 12.5.
• NOTE: Glass may discolor over time. Soak glass in a deter-
gent bath to bring back the original crystalline finish.
Figure 12.5. Fire Glass layout.
130112_Rev 2 GF 160 DV 2/22
21