CYBEX 525T Service Manual page 177

4. Lift and remove the elevation motor from the treadmill.
Calibrate Incline motor 525T
1. Plug the incline motor cable into the motor controller connector.
2. Install the ground wire screw securing the ground wire using a Phillips screwdriver.
3. Connect the main power cord into the power outlet.
4. Turn the main power switch to the on (I) position.
The incline motor will now rotate to find the zero percent position.
5. Wait for the incline motor to stop turning.
6. Turn the tube nut with your fingers until it measures the correct center to center length. This length
is measured from the center of the top hole to the center of the bottom hole.
7. Unplug the power cord from the power outlet.
Cybex 525T Treadmill Part Number
Item
Item
Page 177 of 199
Description
1 Motor Controller Connector
2 Incline Motor Cable
3 Ground Wire Screw
4 Ground Wire
Description
Center to center
1
length
2 Tube Nut
Qty.
1
1
1
1
Qty.
11.75" (29.8
cm)
1