CYBEX 525T Service Manual page 174

6. Connect the black cable from the motor controller to the terminal on the line filter.
Install shield
Using a Philips screwdriver tighten the seven screws securing the shield to the base.
Install motor cover
1. Place the motor cover into position vertically by aligning the two tabs and four plastic connectors.
Two plastic connectors are mounted in the front cover and two in the motor cover. If motor cover
top does not fit properly, loosen the side screws as needed.
2. Tighten the two front cover screws using a Phillips screwdriver.
Be sure the screws are securing the motor cover's tabs.
Complete installation
1. Plug the power cord into the power outlet.
2. Verify the power cord is not being pinched under the front of the treadmill.
3. Operate the unit at all levels to verify proper operation.
Cybex 525T Treadmill Part Number
Item
Item
Page 174 of 199
Description
1 Base
2 Screws
3 Shield
Description
1 Motor Cover
2 Front Cover
3 Screws
4 Plastic Connectors
Qty.
1
7
1
Qty.
1
1
2
4