CYBEX 525T Service Manual page 125

2. Install the bolt, washer, bushing and rear roller nut for each side of the roller into position.
3. Tighten the two rear roller bolts using a 3/4" Socket wrench.
Tighten each bolt evenly, making sure not to tighten either bolt too many turns before moving to the
other bolt.
4. Continue to tighten bolts until the front roller is all the way back in the tensioning slots.
5. Tighten the front roller bolts using a 9/16" Socket wrench.
6. Tighten the rear roller bolts to 100 in-lbs (11.3 Nm) using a torque wrench.
Install top steps
1. Install the five screws and five screw cover bases securing the right top step using a Phillips
screwdriver.
Do not tighten screws at this time.
2. Install the five screws and five screw cover bases securing the left top step using a Phillips
screwdriver.
Cybex 525T Treadmill Part Number
Item
Page 125 of 199
Item Description
1 Rear roller nut
2 Bushing
3 Washer
4 Bolt
5 Rear roller
Description
1 Screw cover
2 Screw
3 Screw cover base
4 Top step, right
Qty.
1
1
1
1
1
Qty.
5
5
5
1