CYBEX 525T Service Manual page 160

Remove motor cover
1. Loosen, but do not remove the two front cover screws securing the motor cover using a Phillips
screwdriver.
2. Remove motor cover by carefully lifting vertically. Do not break the four plastic connectors.
Remove shield
1. Loosen, but do not remove the seven screws securing the shield to the base using a Phillips
screwdriver.
2. Remove shield by sliding sideways and then vertically off of base.
Disconnect cables from motor controller
Pulling cables by their wires can damage the cables. Remove cables by pulling from connectors.
Carefully un-latch the cable connectors from the motor controller. This includes; the power in (INPUT),
display cable (COMM.), elevation cable (INCLINE), drive motor cable (OUTPUT) and resistor (DB).
Cybex 525T Treadmill Part Number
Shock and electrocution hazard.
• Unplug unit and let sit 10 minutes before cleaning or performing
maintenance.
• Electrical charge can remain in unit after unplugging.
• Keep water and liquids away from electrical parts.
Page 160 of 199
Item Description
1 Motor Cover
2 Front Cover
3 Screws
4 Plastic Connectors
Item Description
1 Base
2 Screws
3 Shield
Qty.
1
1
2
4
Qty.
1
7
1