Fostex G24S Owner's Manual page 37

his function displays, on the MEMORY display, the remaining time from the present positron of the tape
to the end point of the zone limit section. As this can be displayed even when the G16 is in the play
mode, it is a convenient feature when the remaining time of the ta pe is short.
his function displays the zone limit section length (time value) on the MEMORY Display. When the
zone limit is functioning, record and playback modes are possible for the time length displayed here.
his function enters the base thickness of the tape in use (for automatic calculation of the zone limit) and
is helpful if the following problem occurs:
he tape still runs beyond the zone limit contrary to expectation (off the reel). Improper tape base thick ­
ness can be one of the causes. In this case, change the base thickness data using the function
explained below:
(a) Press in order: RCL key, +10 key. he value
of the base thickness registered in the mem ­
ory, such as ' ape 52", will be shown on the
MEMORY display (the base thickness of this
example is 52 microns).
ITCEXT OEN EDtT
N M S F
(b) o enter the new base thickness within the 20
~ 99 range, use the numerical keypad (error
wilt be indicated if a value outside this range
Is input). Make the value larger if the tape
runs beyond the zone limit; make it smaller if
the zone limit range is too narrow.
(c) When the S O Key and +10 Key are pressed
in order, the value displayed in step 2 above
will be registered. he contents registered here
will be battery backed up even if the main
power is switched OFF.
Default value (initial value at shipping from
plant), is 52.
-35-