his function displays the presently setup zone limit section on the APE IME display and MEMORY
display, and can be used to change its contents.
•
Method of Display/Setup of Zone Limit Section
(a) When the RCL key and ZONE LIMI button
are pressed in order, the presently set zone
limit section will be displayed on the APE
IME display and MEMORY display as shown
in the right-hand figure: In this example the
zone limit section, with the takeup side (start
of winding side) set at 45 seconds on the
APE IME display, and the supply side (end
of winding side) set at 29 minutes and 15
seconds on the MEMORY display, are pres
ently stored in the memory. Under these con
ditions, " u" will alternately light to indicate the
zone limit (left end).
cy ifean nomrT
aomtr
bit
l
Q
ouhsijo
(imj *
*
«
r
/suq
When the ZONE LIMI button is pressed to
v
enter the zone limit function, the ZONE LIMI
LED, will light if the present tape position is
~ —
50seconds, and blink if it is 29 minutes 20
seconds.
Supply reel side (left side)
(b) o change this setting, either shift the MEM
ORY display cursor by pressing the [ ■ ] key
and enter the new value desired using the
keypad, or, after clearing the MEMORY dis
play by pressing the CLR key, enter the new
value using the keypad (the same as for time
data registering in cue memory). In the follow
ing example, the supply side is changed from
29 minutes to 28 minutes.
» new
mo
un
l
ispq
V
LTCI n
atN
JM)
HMT
* u t f
-33-