Fostex G24S Owner's Manual page 20

(b) Press the RECORD button © to enter input monitor status. he LED of INPU MON will blink. Check
the recording level and sound quality of the source.
(c) After checking all of the recording level(s), press the RECORD button again to cancel input monitor
status. he INPU MON LED will go OFF.
(a) Start the recording by pressing the RECORD and PLAY buttons simultaneously. he RECORD LED
and PLAY LED will light as well as the red SAFE/RDY LED of the track(s) in record ready status.
(b) Upon completing the recording, press the S OP button. he S OP LED will light and the SAFE/RDY
LED will resume flashing red and green (alternately).
(c) urn OFF the SAFE/RDY selector of the track(s) recorded on.
(d) Playback the recording by pressing the PLAY button to check the sound for satisfactory results.
Overdubbing is recording other parts while monitoring the track(s) already recorded.
(a) Select the track(s) you wish to overdub, and set the recording level(s) etc., in the same way as in (1)
on the previous page.
(b) o rehearse while listening to the already recorded tracks before overdubbing, press the PLAY
button only, while in individual input monitor status.
(c) o overdub (take), press the RECORD button, and PLAY button simultaneously after entering record
ready status (any track(s) entered in recording status will go into input monitor status).
Punch-in/out is the process of re-recording a faulty section of previously recorded tape. he starting
point of the recording is called punch-in, and the ending point, punch-out. Using Ihe automatic functions,
auto play, auto return, etc. is very convenient.
Rehearsal
(a) Advance the tape to a point slightly before the punch-in point, and enter the track(s) to record ready
status.
(b) Press the PLAY button to enter all tracks into the tape monitor mode.
(c) Press the RECORD button when the tape arrives at the punch-in point (INPU MON LED will blink).
Only the track(s) set in record ready status will switch from tape monitor to input monitor mode. his
allows the sounds in rehearsal performance to be heard.
(d) Press the RECORD button again when the tape reaches the punch-out point. Monitoring of the
track(s) will then switch back from input monitor to tape monitor. At this point the INPU MON will
turn off.
(e) After completing the rehearsal, press the S OP button.
-18-