Fostex G24S Owner's Manual page 21

Hide thumbs Also See for G24S:

ake

he faulty section will be replaced. he following methods can be used for employing the punch-in/out

process.

Method 1

his method uses the [RECORD] button and [S OP] button.

(a) Set the track(s) to be punched in/out to record ready status and press the PLAY button.

(b) When the tape arrives at the punch-in point, press and hold the PLAY button and then press the

RECORD button, which will accomplish punch-in.

S OP button, his will accomplish a punch-out.

ote

Holding the S OP button longer than about one half of a second will put the G24S/G16S in the full

stop mode.

Method 2

his method uses the [SAFE/RDY] selectors.

(a) Cancel record ready status for all tracks and simultaneously press the RECORD and PLAY

buttons. he READY LED will light.

(b) When the tape reaches the punch-in point, press the SAFE/RDY selector of the track(s) to be

punched in/out. his will accomplish punch-in. he READY LED will go off and the RECORD LED

will light.

to punch-out. At this point the RECORD LED will turn off and the READY LED will light.

Method 3

his method uses the Fostex 8051 foot switch (optional).

(a) Plug the foot switch into the PUNCH-IN/OU jack ® on rear panel.

(b) Enter the track(s) to be punched in/out to record ready status, and press the PLAY button.

punch-in.

(d) Step on the foot switch once again when the tape arrives at the punch-out point to punch-out.

he cueing feature is used to search for a desired point you wish to edit while monitoring the sound

using the CUEING dial, or, to find the head of a song. he cueing mode can be entered only from the

S OP mode.

•

Method of Cueing

1. Press the EDI button to initiate the cueing mode. he EDI LED will light indicating this mode

has been entered.

he tape will advance toward the takeup reel (right hand reel) when the CUEING dial is rotated

clockwise. ape speed increases as the CUEING dial is further rotated CW.

-19-

G16s