Fostex G24S Owner's Manual page 17

he following is one example of possible connections for the G24S/G16S.
a) Connection of Foot Switches
c) Connection of Mixer
Connect the optional Fostex 8051 foot
switches to the PUNCH-IN/OU jack or the
PLAY/ LOCA E jack, respectively, in the rear
panel.
b) Connection of Patch Bay
Connect GROUP OU 1 - 8(4) of the mixer
with the optional Fostex patch bays 3011,
3012, or 3013. hen, using a multi-cable, wire
into INPU S 1 - 12(8) of the G24S/G16S. In
Wie case of using an 12(8) group out mixer, a
patch bay is not necessary.
Wire OU PU S 1 - 24(1 - 16) of the
G24S(G16S) to APE IN of the mixer; use
three(two) 8-channel cables accordingly.
OTE
Multi-cables are optional. here are 4 or 8
channel color cables available.
(MODEL 8041-8048)
d) Connection of Controller
If you wish to locate the controller at your con ­
sole, remove the controller from the front panel
of the G24S/G16S. Using the optional exten ­
sion cable, (Fostex 8546) connect the control ­
ler to Wie CON ROLLER terminal in the rear
panel. hen set the FRON /REAR switch of
OTE
Each of the INPU S 13 - 24(9 -16) of the
G24S/G16S are connected in parallel with
-15-