Fostex G24S Owner's Manual page 33

2. Individual Input Monitor 2 (In Mon 2)
v
Individual input monitor 2 mode is entered in the
same way as input monitor 1 (by pressing the
RECORD button). racks entered into record
ready status and input monitor modes will be
maintained in such modes as fast forward/stop,
but not during playback. When this mode is se ­
lected, the INPU MON LEO will blink quickly,
(the individual input monitor mode is cancelled if
the RECORD button is pressed again).
his is convenient when you wish to listen to any comments of the musician(s) in the booth after play ­
back, and check on the recording taken without pressing the RECORD button again.
. his function displays the last play point on the MEMORY display and the editing of its contents. "Last
play point" is the last point where G24S/G16S had entered playback from the stop mode, and this point
is automatically re-entered in the memory each time the G24S/G16S enters the playback mode;
however, the point where play is entered by auto play or the point where play is entered by pressing the
PLAY button without pressing the S OP button (during fast forward, rewind, etc.) will not be accepted as
the last play point. In other words, the " last play point" is the point where playback is entered by pressing
the PLAY button after the stop mode has been entered by manually pressing the S OP button.
• Method of Display/Editing of Last Play Point
(a) Press in order: RCL key, [ ■ ] key, and the last
play point presently in the memory will be
displayed as shown in the right-hand figure.
he LOCA E LED will blink to indicate that
locating is possible to this last play point.
I
(b) If the last play point must be edited, re-enter
time data using the numerical keypad in the
same way as registering time data in the cue
memory, then press in order : S O key, [ ■ ]
key. he new last play point just registered
will be battery backed up even though the
main power is turned OFF.
IF ITC EXT GEN M> KMT
00.09. » a p
-31 -