GEM R488 Victoria Operating Instructions Manual page 153

16.1.2 Manual override
Electric shock by dangerous voltage!
▶ Risk of injury or death (if operating
voltage is higher than safe extra low
voltage).
Switch off power to the actuator be-
●
fore using the manual override.
Only actuate the manual override when the power is
switched off.
▶ Damage to the actuator!
Set the actuator position to "centred" after using the manual
override!
▶ Trip cams may be outside the limit switches as the limit
switch position was manually exceeded by the manual
override.
▶ Damage to the actuator.
Set the actuator position to "centred" before electrical op-
●
eration.
Attention!
Only
actuate when
power is switched off
Actuator versions
1006, 1015, 2006, 2015
emergency
operation
CLOSED
Actuator version 3035
www.gemu-group.com
DANGER
CAUTION
CAUTION
2 = OPEN
Manual override
1 = CLOSED
2 = CLOSED
OPEN
1 = OPEN
16.1.3 Setting the limit switches
Destruction of the actuator!
▶ Do not move the right limit switch too far to the right and
the left limit switch too far to the left, otherwise the actu-
ator will continue running in the end position (i.e. the limit
switch cannot be actuated by the lever and the actuator
continues to run).
Tools required for setting the limit switches:
Allen key SW3
●
Small Philips head screw driver
●
Always switch the limit switch for signal so that the mo-
●
tor switch is actuated first.
ð Limit switches for signal and motor are already preset.
153 / 172
DANGER
Risk of electric shock!
▶ Risk of injury or death (if operating
voltage is higher than safe extra low
voltage).
▶ Adjustments are made with the actu-
ator cover removed.
▶ Electric shock can cause severe burns
and fatal injury.
Always disconnect the product from
●
power supply!
Therefore, have all work performed
●
only by qualified electricians.
CAUTION
NOTICE
NOTICE
GEMÜ R488 Victoria
16 Operation