Pre-Assembling The Table Top - Dürkopp Adler 650-16 Operating Manual

Installation

11.4 Pre-assembling the table top

Steps
1. Turn over the table top (1).
2. Screw on the drawer (2) with its brackets (chipboard screws
3. Screw on the knee switch (3).
4. Screw on sewing lamp transformer (4).
5. Screw on main switch (5)
6. Screw on the cable duct (6) (40 x 40 x 200 mm length)
7. Screw on strain relief (7)
8. Screw on the auxiliary control unit (8)
9. Screw on the DAC motor controller (9) incl. protective plate
10. Screw on the cable duct (40 x 40 x 250 mm length) (10) (chip-
11. Fit the electrical cables( Chap. 11.9 Electrical connections,
A larger scale illustration is available at the end of the manual (
Chap. 12 Appendix, p. 73).
Instruction manual 650-16 Version 00.0 - 07/2013
Fig. 43: Pre-assembling the table top
8
7
6
5 4
3.5 x 17).
(chipboard screws 5 x 30).
(chipboard screws 3.5 x 17).
(chipboard screws 3.5 x 17).
(chipboard screws 5 x 30).
(chipboard screws 5 x 30).
board screws 3.5 x 17).
p. 58)
10
9
3
2
1
53