Table of Contents
Advertisement
3.2
Assembling the table top
3.2.1
Assembling the table top in the machine with the direct drive
9
7
8
6
5
1
4
3
9
–
Turn the table top (1) upside down.
–
Screw the drawer (2).
–
Put the oil sump (3) on the recess in the table top and slide it in the
arrow direction (4) till the relevant protrusions of the oil sump are
seated on the recess contour. Screw the oil sump.
–
Screw the pedal position senzor (5).
–
Screw the sewing lamp transformer (6) – if there is any.
–
Screw the cable clip (7).
–
Screw the electric cable channel (8).
–
Mount electric cables according to par. 5 of this instruction.
Pre-bore the holes (9) with a borer Æ 3 mm. Attach the table plate
–
(1) to the stand with woodscrews. Then turn the stand to normal
position.
–
Insert the yarn stand (10) in the hole in the table plate and secure it with
the nuts and washers. Fit and align the yarn reel and unwinding holders.
–
Insert the machine head support pin (11).
–
Place the hinge bottoms (12) for the machine head into the cutout
of the table plate (1) and tighten the screws.
–
Insert the wedges (13) in the recess corners.
–
Insert the rubber cushions (14).
–
Remove the blinds from the bushing (15).
–
Remove the knee lever (16) and guide through the opening, as
shown in the illustration.
2
10
14
13
11
12
15
16
EN
5
Advertisement
Chapters
Table of Contents
