Programming Mode; Creating A Program - Dürkopp Adler 650-16 Operating Manual

Operating and programming the control unit

9.8 Programming mode

9.8.1 Creating a program

1. Press the
 The softkey menu appears.
2. Press the
 The following is displayed.
The control unit displays the next available program number.
3. Press "OK" to use the program number.
 The program number is applied.
4. Change the sleeve side or other parameters if necessary (
Instruction manual 650-16 Version 00.0 - 07/2013
button in editing mode.
Fig. 30: Softkey menu
button.
Fig. 31: Select the program number
Or:
Press   to select another program number or use the nu-
/
meric keys "0 - 9" to enter the number and then press "OK".
The following is displayed; "P" flashes.
Fig. 32: Display after defining the program number
Chap. 9.7 Editing mode, p. 42).
45