Operating And Programming The Control Unit; Control Panel Op3000 - Dürkopp Adler 650-16 Operating Manual

9 Operating and programming the control unit

9.1 Control panel OP3000

All settings for the control unit on the 650-16 are made at OP3000
control panel.
26
Fig. 13: Control panel on control unit
A
B
Button Function
0 to 16 Set the fullness
Enter the parameter value (while the field for the parame-
ter is active)
Select a parameter that appears in the display.
• Press the button below the desired symbol.

This selects the function.
ESC Cancel function
Quit the menu
OK Confirm settings
Activate input
P Different function depending on the menu
S Different function depending on the menu
F Different function depending on the menu
Selection to the right

Selection to the left

Go back one menu level
Increase value

Scroll through list (up)
Reduce value

Scroll through list (down)
A Upper softkey 1
Different function depending on the menu
B Upper softkey button 2 - different function depending on
the menu
+/- Change between fullness top and fullness bottom
Operating and programming the control unit
Instruction manual 650-16 Version 00.0 - 07/2013