Table of Contents
Advertisement
160
Fig. 85: Assembling the CCEA sewing light (6)
⑧
(8) - Cable
(9) - Power cable
12. Screw the junction box (10) under the tabletop, paying
attention to the length of the cables.
13. Pull the power cable (9) out of the control and insert it into
the junction box (10).
14. Insert the cable (8) of the junction box (10) into the control.
15. Connect the cable of the sewing light to the junction box (10)
as shown in the wiring diagram (Appendix ( p. 203)).
16. Tighten the cover of the junction box (10) and lay the cables
neatly.
7.15 Assembling the sewing light with table
clamp
NOTICE
Property damage may occur!
Cable may sustain damage and impair the operation of
the machine.
Always lay the cables so as not to create any chafing or
pinching points.
Operating Instructions D669 M-TYPE DELTA - 00.0 - 10/2020
(10) - Junction box
Setup
⑩
⑨
Advertisement
Table of Contents
