Replacing An Air Filter - Siemens SICHARGE D Operating Instructions Manual

9.3.3

Replacing an air filter

The air filters of the charging station remove the dust from the outside air pulled in for
cooling the interior. With increasing operating time, the filtered dust particles reduce the air
flow through the filters. The reduced airflow cools the interior of the charging station less.
This causes the temperature inside the charging station to rise.
The air filters are wear parts. Replace them on a regular basis according to the ambient
conditions, but at least every 12 months, to ensure control of the charging station climate
within the permissible temperature range and to minimize power derating.
Only replace the filter mats when the device is de-energized. For the correct order number of
the spare parts, refer to the document 8EM5907-0AA00-2AA6 Spare Parts List
(https://support.industry.siemens.com/cs/us/en/view/109814736).
Filter mat at front bottom left
The filter mat dimensions are 380 x 480 x 20 mm.
Figure 9-1 Filter mat at front bottom left
1. Remove the protective grille with a TX 30 screwdriver
2. Remove the 2 knurled screws of the holding plate
3. Remove the holding plate
4. Remove the filter mat
Insert the new filter mat with the marking facing out in the reverse order.
SICHARGE D
Operating Instructions, 11/2023, A5E50556539-AG
Maintenance and service
9.3 Servicing the charging station
127