Siemens SICHARGE D Operating Instructions Manual page 87

3. Place the bezel bracket on the left and bezel bracket on the right parallel to the cutout.
Screw the mounting plates down with the 4 M12x30 hexagon screws. Make sure that the
bezel brackets do not twist when screwing in. Do not tighten the screws yet.
Figure 5-12 Screwing the mounting plates
4. Place the bridge between the left and right mounting plates. The four threaded bolts must
pass completely through the holes of the bridge. Screw in the bridge with four M6 hex
nuts. Do not tighten the nuts yet.
Figure 5-13 Screwing in the bridge
SICHARGE D
Operating Instructions, 11/2023, A5E50556539-AG
Installation and mounting
5.5 Setting up the charging station
87