Siemens SICHARGE D Operating Instructions Manual page 65

Transporting the charging station with a crane
Ensure adequate carrying capacity, depending on the hoisting gear used. Maintain an angle
of inclination of ≤45° between the chain and the perpendicular at the attachment point. We
recommend, for example, a standard harness with 1 m sling chains of grade 8 or higher.
To transport the charging station to the installation site with a crane, proceed as follows:
1. Attach the accompanying eyebolts to the four corners of the roof of the cabinet frame.
Screw in the lifting eyebolts completely until the contact surfaces are level and fully in
contact. Avoid improper loading (see figure).
Figure 4-2 Standard load (left) and impermissible load (right)
When using your own lifting eyebolts, make sure that:
– Lifting eyebolt corresponds to at least the requirements of DIN 580
– 25 to 30 mm long M12 thread
– Suitable for weight of the charging station
– Follow the respective mounting instructions
2. Hook the hoisting gear into the eyebolts.
3. Lift the charging station vertically
SICHARGE D
Operating Instructions, 11/2023, A5E50556539-AG
DANGER
Suspended load
A falling charging station or parts can cause death or serious injury. Stay completely away
from any hazardous areas.
Transport and storage
4.1 General information
65