Specific Installer Safety Instructions - Daikin Altherma 3 R MT F Series Installer's Reference Manual

Table of Contents

Advertisement

3
|

Specific installer safety instructions

3 Specific installer safety instructions
Installer reference guide
16
INFORMATION
This unit is a heating only model. Therefore, all references to cooling in this
document are NOT applicable.
Always observe the following safety instructions and regulations.
Handling the unit (see
CAUTION
To avoid injury, do NOT touch the air inlet or aluminium fins of the unit.
Application guidelines (see
CAUTION
The solar panels MUST be installed higher than the indoor unit. A downward slope
with minimum gradient of the solar piping MUST be guaranteed. This is to allow the
solar system to completely drain and thereby to avoid frost damages.
WARNING
When opening the tapping point, the water temperature can be up to 55°C.
"7 Unit
Unit installation (see
WARNING
Installation shall be done by an installer, the choice of materials and installation shall
comply with the applicable legislation. In Europe, EN378 is the applicable standard.
Installation site (see
"7.1 Preparing the installation
WARNING
Follow the service space dimensions in this manual for correct installation of the unit.
Outdoor unit: See
Indoor unit: See
WARNING
The appliance shall be stored in a room without continuously operating ignition
sources (example: open flames, an operating gas appliance or an operating electric
heater).
WARNING
DO NOT reuse refrigerant piping that has been used with any other refrigerant.
Replace the refrigerant pipes or clean thoroughly.
"4.1.1 To handle the outdoor
"6 Application
guidelines" [
installation" [
4
 51])
"17.1 Service space: Outdoor
"7.1.3 Installation site requirements of the indoor
4
unit" [
 23])
4
 33])
4
site" [
 51])
4
unit" [
 279].
4
unit" [
ERRA08~12E + ELVZ12S18+23E
Daikin Altherma 3 R MT F
4P708478-1 – 2023.05
 54].

Advertisement

Table of Contents
loading

Table of Contents