Planar UltraRes L Series User Manual page 87

Power Submenu
Auto Power On
•
If set to On, the display will automatically leave standby after AC power is applied
•
Options: On, Off; Default: Off
Power Saving Mode
•
Set the action to take if there is no signal detected after the period of time specified by the
Power Saving Delay setting
•
Options: Disabled, Power Down, Wake on Signal; Default: Disabled
•
Disabled: Once powered on, the display will remain on even if no signal is present.
•
Power Down: The display will enter a standby state specified by the Power Down
Mode setting.
•
Wake On Signal: The display will enter a standby sleep mode if no signal is detected.
The display will wake when signal is restored.
•
Note: When signal is restored, a 10-15 second wait is typical to have an image
displayed.
•
Note: The display must be allowed to enter sleep mode due to lack of signal for
Wake On Signal to take effect. Sending an OFF command via Keypad, IR, CEC,
RS232 or LAN will bypass Wake On Signal detection, and the display will enter the
power state specified in the Power Down Mode setting.
•
Note: If Auto Scan Sources is enabled in the Inputs and Views menu, the
display will sequentially scan all inputs before entering sleep mode. The display will
leave sleep mode when a signal is detected on any input.
•
Note: If Auto Scan Sources is disabled in the Inputs and Views menu, the
display leave sleep mode only when a signal is detected on the last selected input.
•
Note: When Wake On Signal is selected, the LAN port and Remote Monitoring
web interface will remain accessible after the display enters sleep mode.
Planar UltraRes L Series User Manual
020-1427-00A
87
Page | 87