Table of Contents
Advertisement
Preparing the Wall for Wall Mounting
1. Make sure that the wall and the mounting hardware are capable of supporting the weight
of the entire display configuration.
Check the "Specifications" section on page 138 for component weights.
2. A wall/structure that is flat within ±3mm (1/8") and plumb is highly recommended as a
starting point.
3. Plan and route remote cabling prior to mount installation. When installing on a solid
structure, consider where the mounts will be and plan to have cable ingress between the
mounts near the left side of the display.
4. Determine and mark a vertical and horizontal line of the center of the image of the unit.
For mount location verification, it is optional to continue the line or mark the left and right
most edge of the image as well as the top.
Center Point
of Image
Planar UltraRes L Series User Manual
020-1427-00A
33
Display Outline
Image Outline
[47.0in]
1194mm
Minimum
Floor
Page | 33
Advertisement
Table of Contents
