Planar UltraRes L Series User Manual page 27

4. Noting the orientation of threaded holes along the left wings lower face, place the end of
the left wing over the lower hole pattern on the top of the vertical column engaging the
alignment pins between the parts as shown.
Threaded Holes
Threaded Holes
Orientation
Left Wing
5. Noting the orientation of threaded holes along the left wings lower face, place the end of
the second left wing over the lower hole pattern in the middle of the vertical column as
shown above.
Planar UltraRes L Series User Manual
020-1427-00A
27
Orientation
Lower Hole
Pattern
Alignment Pins
Under Flange
Page | 27