Planar UltraRes L Series User Manual page 25

Assembling Rolling Floor Stand
If mounting to a structure skip to the "Preparing the Wall for Wall Mounting" section on page 33.
1. The rolling floor stand can hold the display at two heights, 2400mm (94.5") and 2500mm
(98.5") from the ground. The following procedures show the lower rolling floor stand
assembly. If mounting the desired height of 2500mm (98.5"), use the hole patterns labeled
with 800 instead of 700 where appropriate.
2. Position the two vertical column assemblies as shown on a flat surface. Noting the
orientation of threaded holes along the support beams lower face, place the ends of the
first support beam over the lower hole pattern on the top of the vertical columns engaging
the alignment pins between the parts as shown.
Threaded Holes
Orientation
Threaded Holes
Orientation
Planar UltraRes L Series User Manual
020-1427-00A
25
Lower Hole
Pattern
Support
Beam
Vertical Column
Alignment Pins
Under Flange
Assembly
Page | 25